Load Interval
Bandwidth Utilization
Information

Release 1.0

System Administration Commands

 

 

load-interval

The load-intervalcommand specifies the load interval timer value in minutes. The load interval timer captures bandwidth utilization information on a per-port basis for both received and transmitted data. Bandwidth utilization information can then be displayed with the show interfaces command. The following is typical load interval information as displayed with the show interfaces command:

Cable2/0 is up, line protocol is up

Hardware is BCM3210 ASIC, address is 0030.7b74.3238 (bia 0030.7b74.3238) Internet address is 10.10.128.1/17

MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 20/255 Encapsulation MCNS, loopback not set Keepalive not set

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 69 drops; input queue 0/75, 7 drops

5 minute input rate 2202000 bits/sec, 416 packets/sec

5 minute output rate 120000 bits/sec, 13 packets/sec

1125177443 packets input, 14081732 bytes, 25 no buffer Received 3125750 broadcasts, 0 runts, 0 giants, 0 throttles 1018 input errors, 87 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 25006326 packets output, 1183354279 bytes, 0 underruns

0 output errors, 0 collisions, 4 interface resets

0 output buffer failures, 0 output buffers swapped out

Group Access

All

Command Mode

Interface Configuration

Command Line Usage

load-interval <1-300>

Command Syntax

526363-001-00 Rev. B

MGBI

1-57

Page 93
Image 93
Motorola BSR 2000 manual Load-interval