Release 1.0

CMTS Commands

 

 

cable upstream description

The cable upstream description command is used to specify descriptive information for a upstream port on the BSR. This information is limited to 80 characters and single word descriptions are not allowed. Use the characters: _ or - to separate words. For example, if a upstream port served a certain section of a city, the MSO could assign the following description:

MOT(config-if)#cable upstream 0 description charlestown_1U

Note: The entered description can be seen in the running configuration, and in the command output of show commands such as the show ip interface and show running-configcommands.

Command Mode

Interface Configuration (cable interface only)

Command Line Usage

cable upstream <NUM> description <LINE>

Command Syntax

NUM

is the upstream port number.

LINE

is the text that describes the interface.

526363-001-00 Rev. B

MGBI

11-77

Page 623
Image 623
Motorola BSR 2000 manual Cable upstream description, MOTconfig-if#cable upstream 0 description charlestown1U