Release 1.0 | CMTS Commands |
|
|
show cable modem stats
The show cable modem stats command displays the following statistics for each cable modem on a CMTS module. This includes cable modems that are
Interface | cable modem interface with active |
| connection |
Prim Sid | Primary Service Identifier number |
Connect State | describes the connectivity state of a cable |
| modem. The table below describes the 20 |
| cable modem connectivity states |
| supported on the BSR. |
Mac Address | cable modem Media Access Control layer |
| address |
Registration Time | the length of time a cable modem has been |
| registered in ddd:hh:mm:ss format |
TxKbytes | the number of unicast Kbytes that have |
| been transmitted |
RxKbytes | the number of unicast Kbytes that have |
| been received |
The following is an example of typical screen output from the show cable modem stats command:
Interface | Prim | Connect | Mac Address | Registration | Tx | Rx |
| Sid | State |
| Time | Kbytes | Kbytes |
Cable 4/1/D1U1 | 8 | online(pt) | 000b.0643.3bb2 | 000:19:08:35 | 154 | 269 |
Cable modem connectivity states are as follows:
init(r1) | CM sent initial ranging parameters. |
init(r2) | CM is ranging. |
init(rc) | ranging is complete. |
dhcp(d) | DHCP Discover was sent by CM. |
dhcp(o) | DHCP Offer was received. |
dhcp(req) | DHCP Request was sent by CM. |
MGBI |
