Release 1.0

System Administration Commands

 

 

show logging reporting

The show logging reporting command displays the recording mechanism for logging messages based on their severity level. The display output is in the format: logging reporting <severity> <logging location> e.g. logging reporting alert local. The following is an example of typical screen output from the show logging reporting command:

no logging control docsis

logging reporting emergency local logging reporting alert local

logging reporting critical local-trap-syslog logging reporting error local-trap-syslog logging reporting warning local-trap-syslog logging reporting notice local-trap-syslog logging reporting information all-clear logging reporting debug all-clear

The following information is displayed:

Severity Levels and Descriptions

emergency

emergency conditions where the system is unusable -

 

reserved for vendor-specific, fatal hardware or software

 

errors that prevents normal system operation and causes

 

reporting system to reboot

 

(severity level = 0)

alert

conditions where immediate action is needed - a serious

 

failure which causes the reporting system to reboot but is

 

not caused by hardware or software malfunctioning

 

(severity level = 1)

critical

critical conditions - a serious failure that requires

 

immediate attention and prevents the device from

 

transmitting data but the system could recover without

 

rebooting

 

(severity level = 2)

526363-001-00 Rev. B

MGBI

1-119

Page 155
Image 155
Motorola BSR 2000 manual Show logging reporting, Emergency