QMS 1800486-001C, QMS magicolor 2 DeskLaser manual Erasing flash

￿￿￿￿￿￿￿￿￿￿￿￿￿￿&￿￿￿￿

￿￿￿￿￿$￿￿

This message...	indicates...		Do this...
Ethernet error	An Ethernet error has occurred:		Record the error num-
	101	Hardware address conflict	ber, if one is given, and
			then contact your sys-
	103	mem err
			tem administrator or the
	104	appinit
			QMS Customer
	105	net err
			Response Center.
	106	net err
	107	event err
	108	event err
	109	Ethernet address conflict
	110	err
	111	err
	112	couldn’t program physical
	113	err
	114	RARP err
	115	couldn’t program logical address
	124	snetopen err
	125	netxopn err
	126	makeport full
	241	shift err
	242	fifo count error
Erasing flash	The flash ROM is erasing the old ROM		No action needed.
	when you are installing a new system.
F# xxxxxxxx xxxx	There is a processor fault.		Call for service.
i960 fault
Flash error	There is a flash ROM problem.		Call for service.
Front panel	The front cover is not closed.		Close the front cover.
Misinstalled
Fuser c. roller	The fuser cleaning roller is either		Install the fuser cleaning
Misinstalled	incorrectly installed or missing.		roller correctly.
Fusing unit	The fuser is either incorrectly installed		Install the fuser
Misinstalled	or missing.		correctly.
HW err 0	The Ethernet hardware address is not		Use the Ethernet HW
Press cancel	set.		(Hardware) Address
			menu to set the
			hardware address.
Idle	No jobs are in progress.		No action needed.

-￿!￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿