Windows NT 4.0 Configuration
16
2
Preparing to Use the TCP/IP Protocol for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the TCP/IP protocol.
Configuring the Printer
Configure your printer to use the TCP/IP protocol.
Confirm that the TCP/IP protocol is set to be active. (The factory default is ac-
tive)
Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information on how to make the above settings, refer to the Operat-
ing Instructions for your printer.
If DHCP is used to assign IP addresses, refer to P.82 “When Using DHCP”.
Note
After setting the IP address, use the PING command to confirm that it has
been set correctly.
AClick [
Start
], point to [
Programs
], and then click [
Command Prompt
].
BInput the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.