Appendix
64
5
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set

protocol

{up | down}
Note
❒If you prohibit remote access using TCP/IP and then logout, you cannot use
remote access. If this was a mistake, you can use the printer operation panel
to allow access by TCP/IP.
❒When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp, rsh, diprint, and web.
Status of Printer
The following commands can be used to get information about the current status
of the printer.
msh>

command

Note
❒More information on the print job is displayed when the ID number is added
after the prnlog command.
Protocol
appletalk
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web
“Up” means active and “Down”
means inactive.
Command Information that is displayed
status Status of printer.
Information about the print job.
info Information about the paper tray, outpu t
tray, emulation and program of printer.
prnlog [ID] Lists the last 10 print jobs.
netstat Information on the Network Interface
Board.