RuggedCom RX1000, RX1100 manual Firewall Rules, Editing a Masquerading Rule

RuggedRouter™ User Guide

This menu allows you to add, delete and configure masquerading and SNAT rules. Add a new rule by selecting the “Add a new masquerading rule” link or by clicking on the add-above or add-below images in the Add field. Reorder the policies by clicking on the arrows under the Move field.

Clicking on a link under the Outgoing interface field will allow you to edit or delete the rule, as shown below. You may also make changes by manually editing the rule file.

Figure 98: Editing A Masquerading Rule

The Only for destination field restricts the masquerading to the specified IP address.

The Network to masquerade fields determine the interface or subnet on the private network that you wish to masquerade. The Except for networks field restricts traffic from the specified subnet.

The SNAT address field is used to determine whether masquerading or SNAT is being performed. If checked, the entered IP address is used as a SNAT address.

Firewall Rules

Figure 99: Firewall Rules

This menu allows you to add, delete and configure firewall rules. These rules are inspected and applied before the default policies are used. Add a new rule by selecting the “Add a new firewall rule” link or by clicking on the add-above or add- below images in the Add field. Reorder the policies by clicking on the arrows under the Move field.

Clicking on a link under the Action field will allow you to edit or delete the rule, as shown below. You may also make changes by manually editing the rule file.

Figure 100: Editing A Firewall Rule

118 RuggedCom