RuggedCom RX1100, RX1000 manual Appendix a Setting Up a Repository, Repository Server Requirements

Appendix A – Setting Up A Repository

Appendix A – Setting Up A Repository

The RuggedCom software upgrade mechanism requires a repository of software to available. The following instructions detail:

∙Requirements for a repository server,

∙Initial set up of a repository,

∙Upgrading the repository to the latest release,

∙Maintain separate releases streams for different groups of routers,

∙Setting up one router to test new releases

∙Configuring the network routers.

Repository Server Requirements

In order to establish a repository you will need a host that is accessible to the routers that will be upgraded. This host must be able to act as a web server or ftp server. The host must also be able to access the RuggedCom web site in order to download new releases of software from RuggedCom.

The server requirements are fairly modest. The principal requirements are for disk space, bandwidth and the ability to serve an adequate number of http sessions.

Each software release will require approximately 50 Mb of disk space. Note that this figure includes an entire software image, most upgrades will involve the transfer of only a small fraction of this amount. A large number of such releases could easily be stored on a system of only modest capabilities. In practice, only one or two releases are usually all that need be kept.

The bandwidth requirements are determined by the many factors including the number of routers, size of upgrade, when the routers upgrade, bandwidth limiting at each router and network bandwidth capability. Most web servers can serve files to the limit of the network interface bandwidth, so even a modest (e.g. 486 class machine) would prove acceptable.

The server should be able to accept at least as many http or ftp connections as there are upgradable routers in the network. In practice you will configure the routers to have staggered upgrade times in order to minimize the impact of upgrading on the network. A large upgrade (or a low bandwidth limiting value at each router) may cause all the routers to be upgrading at any one time.

Initial Repository Setup

You must create a directory on the web server to hold the releases for the router. The directory can have any name, such as “ruggedrouter”.

Some administrators like to designate one router to test the impact of new software. This will require a directory, such as “ruggedroutertest” to be created.

These directory names will be used in examples in the remainder of this section. Ensure that the web server publishes these directories.

RuggedCom 267