RuggedRouterâ„¢ User Guide

This menu allows you to make permanent changes to interfaces and to immediately apply those changes if desired. The Save button will save changes to the permanent configuration.

The Netmask, Broadcast, MTU, Virtual Interfaces, Proxy ARP and Media Type controls are as described above.

The IP Address fields allow you to manually specify an IP address for this interface, or to obtain the address from DHCP or from BOOTP.

The Activate at boot fields allow you permanently disable the interface without actually deleting it.

The Save and Apply button applies any changes after they have been saved. The Delete and Apply button deletes both the boot time and active interface.

The Delete button deletes the boot time interface but leaves the active interface in existence.

PPPoE On Native Ethernet Interfaces

Figure 47: List PPPoE Interfaces

This menu allows you to display and configure the PPPoE interfaces on all available Ethernet ports.

The PPPoE Interfaces table allows you to add a PPPoE interface on an Ethernet ports or change PPPoE interface parameters of created interfaces. Only one PPPoE interface can be created on each Ethernet port.

The Ethernet field shows all available Ethernet ports.

The Interface Name field shows created PPPoE interfaces and provides a link to edit the existing configuration or create a new one.

The MTU, Use Peer DNS and Default Route fields are the configured information for PPPoE interfaces.

The Status field shows the current PPPoE link status.

62

RuggedCom

Page 64
Image 64
RuggedCom RX1000, RX1100 manual PPPoE On Native Ethernet Interfaces, List PPPoE Interfaces