Chapter 7 – Configuring Frame Relay/PPP And T3

Upgrading Software

For some customers, access to remote sites in accomplished solely by a T3 connection. Usually a software upgrade will stop the system being upgraded, perform the upgrade and then restart it. If T3 port was upgraded in this way, the upgrade would fail as the T3 link was taken down. Instead, T3 software upgrades modify only the software on the disk. You must schedule a reboot in order to run the new version of T3 software.

RuggedCom

81

Page 83
Image 83
RuggedCom RX1100, RX1000 manual Upgrading Software