RuggedRouter™ User Guide

This menu allows you to add, delete and static NAT translations. Add a new translations by selecting the “Add a new static NAT entry” link or by clicking on the add-above or add-below images in the Add field. Reorder the translations by clicking on the arrows under the Move field.

Clicking on a link under the External Address field will allow you to edit or delete the rule, as shown below. You may also make changes by manually editing the rule file.

Figure 102: Creating a Static NAT Entry

The External address and Internal address fields specify the addresses to translate. describe the information to match against the incoming connection request in order to apply this rule.

The External interface field specifies the interface to perform the translation upon.

The Active for all hosts field is used to specify whether access to the external IP from all firewall interfaces should undergo NAT (Yes or yes) or if only access from the interface in the INTERFACE column should undergo NAT.

The Active for firewall system field is used to specify whether packets originating from the firewall itself and destined for the EXTERNAL address are redirected to the internal ADDRESS.

Actions When Stopped

Figure 103: Actions When Stopped

120

RuggedCom

Page 122
Image 122
RuggedCom RX1000, RX1100 manual Actions When Stopped, Creating a Static NAT Entry