RuggedRouter™ User Guide

The last 2-bytes of the VLAN tag contain the following information: the first 3-bits are a User Priority Field that may be used to assign a priority level to the Ethernet frame. The next 1-bit is a Canonical Format Indicator (CFI) used in Ethernet frames to indicate the presence of a Routing Information Field (RIF). The last 12-bits are the VLAN Identifier (VID) which uniquely identifies the VLAN to which the Ethernet frame belongs.

RuggedRouter Functions Supporting VLANs

Functions

Supported

Comments

 

?

 

 

 

 

Static Route and Default

Y

 

Route

 

 

Static Multicast Routing

Y

 

 

 

 

End To End backup

Y

 

 

 

 

PPPoE

N

 

 

 

 

Shorewall Firewall

Y

 

 

 

 

IPSec

N

Netkey (policy based VPNs) supports VLAN

 

 

Klips (route based VLANs) do not support

 

 

VLAN

VRRP

Y

 

 

 

 

Traffic Prioritization

Y

 

 

 

 

Dynamic Routing

 

Both OSPF and RIP support VLAN

 

 

 

GRE Tunnel

Y

 

 

 

 

DHCP Server

Y

 

 

 

 

PPPoE On Native Ethernet Interfaces Fundamentals

The RuggedRouter supports PPPoE (Point-to-Point Protocol Over Ethernet) over both external modems (described here) and internal interfaces (described in the chapter “PPPOE On ADSL”). The PPPOE On ADSL chapter contains more useful information on PPPOE Authentication, Addresses, DNS Servers and MTU Issues.

Only one PPPoE interface can be created on each Ethernet Interface. Each PPPoE interface name is assigned internally. The name is “pppX”, where X is 10 plus the native Ethernet interface the PPPoE is created upon (e.g. a PPPoE on eth1 is ppp11).

58

RuggedCom

Page 60
Image 60
RuggedCom RX1000, RX1100 manual PPPoE On Native Ethernet Interfaces Fundamentals, RuggedRouter Functions Supporting VLANs