Chapter 20 – Configuring GOOSE Tunnels

General Configuration Menu

Figure 165: General Configuration Menu

This menu configures the daemon settings.

The Daemon UDP Listen Port field configures port used by the daemon to communicate with other daemons.

Note: All Layer 2 Tunnel daemons in the network must use the same port number. If the router employs a firewall, ensure that a hole is opened for each of the remote daemons using on this port number.

The Beacon Interval field configures how often a Round Trip Time (RTT) measurement message is sent to each remote peer. The interval takes the values “Off” to disable RTT measurement or a time of 10 – 3600 seconds.

GOOSE Tunnels Menu

Figure 166: GOOSE Menu

This menu displays GOOSE tunnels. Configure an existing tunnel by following the link under the Ethernet Interface field, or add a new tunnel.

Figure 167: GOOSE Menu

This menu configures a GOOSE tunnel.

The Ethernet Interface field configures suitable (i.e. VLAN eligible) interfaces to listen for GOOSE frames upon. You may set this field to “none” if the intent is simply to relay network packets.

RuggedCom

197

Page 199
Image 199
RuggedCom RX1100, RX1000 manual General Configuration Menu, Goose Tunnels Menu