Emerson AC8 Pager Setup Pager Number and PIN, Pager dialing results, Select a Pager to Configure

System and Control Options

7.8.3Pager Setup - Pager Number and PIN

The AC8 may be configured to dial numeric or alphanumeric pagers when an alarm is detected. You may enter up to four pager numbers—all configured pagers will be dialed each time an alarm occurs. For each configured pager, you must enter the pager number to be dialed and the pager’s Personal Identification Number (PIN).

See 8.1 - AC8 Specifications for supported pager settings.

The AC8 can send numeric or alphanumeric messages to supported pagers, as shown in the following example:

Alphanumeric pager message example

LIEBERT TEST DEVICE_1 ALARM CONTACT CLOSED

2:07 PM 06/09/04

Pager company time stamp

When an alarm is detected, the first pager number is dialed—up to three times, if needed. After a suc- cessful page or three dialing attempts, the next pager number is dialed, again with three attempts as needed, and so on for all configured pagers.

Table 23 Pager dialing results

Result of Page	Action	Message Generated
Successful	AC8 dials next configured pager.	—
Unsuccessful due to:
Busy signal / no answer /	AC8 generates message after all three redial attempts	Unsuccessful Page
no dial tone	have failed, dials next configured pager.	(Event Log)
General modem	AC8 resets modem, generates message, redials pager	Modem Reset
communication problem	up to three more times.	(Event Log)
No communication with	AC8 generates messages, makes no further dialing	Modem Internal Fault
modem	attempts.	(Active Alarm Report,
(internal hardware problem)		Alarm History Log)

To configure a pager:

Log In and Choose Setup System

• From the Main Menu, use the arrows ↑↓ to choose System and Control, then press Enter ↵ (see 7.1 - Login for help).

• Enter your password at the Login screen.

• From the System and Control Menu, use the arrows ↑↓ to choose Setup System, then press Enter ↵ .

Select a Pager to Configure

•From the Setup System Menu, shown at right, use the arrows ↑↓ to choose Setup Modem&Pagers and press Enter ↵ .

•Use the arrows ↑↓ to choose Setup Pagers from the Pagers & Modem Menu, and press Enter ↵ .

•From the Select Pager Menu, choose the pager number you want—for example, Pager Number 1—and press Enter ↵ .

Setup System Menu

SETUP INPUTS SETUP COMMON ALARM SETUP SENSOR

↑↓ =NEXT ↵ =SELECT

SETUP ZONES

SETUP OUTPUTS

>SETUP MODEM&PAGERS SETUP SYSTEM INFO SETUP OPERATION SETUP I/O MATRIX

Pagers & Modem Menu

>SETUP PAGERS SETUP MODEM

↑↓ =NEXT ↵ =SELECT

Select Pager Menu

SELECT PAGER

>PAGER NUMBER 1

PAGER NUMBER 2

↑↓ =NEXT ↵ =SELECT

PAGER NUMBER 3 PAGER NUMBER 4

53