RuggedCom RX1100, RX1000 manual Static Multicast Routing

Chapter 4 – Configuring Networking

Static Multicast Routing

Figure 36: Static Multicast Routing

This menu allows you to configure static multicast routing.

The Configured Static Multicast Routes table shows configured multicast routes.

New routings may be added by completing the bottom row of the table and selecting the Save button. Routings may be deleted by clearing the routings Multicast IP Address field and selecting the Save button.

The Multicast IP Address field specifies the multicast IP address to be forwarded.

The Input Interface field specifies the interface upon which the multicast packet arrives.

The Source IP Address specifies the multicast packet's expected source IP address.

The Output Interface specifies the interface to which the matched multicast packet will be forwarded.

The Comment field shows the current status of the the routing. The Note field below the table shows current active interfaces.

In order to start Multicast routing at each and every boot, you must enable it via the System folder, Bootup And Shutdown menu.

RuggedCom 53