RuggedCom RX1000, RX1100 manual Change Alert Definition

RuggedRouter™ User Guide

Change Alert Definition

Figure 205: Change Alert Definition Menu

This menu allows you to change an existing alert definition entry.

The Codepoint is the key part of the alert definition entry and does not allow to be changed.

The Category configures which category the alert definition entry belongs to.

The Name configures the name of the alert definition which will be displayed by webmin, login or email forwarder when an active alert exists.

The Subsystem configures which subsystem the alert definition entry belongs to.

The Severity configures the severity level of the alert. The severity level is sorted from highest priority to lowest priority.

The Alarmable configures whether the matched alert should trigger the critical relay and alarm LED on the LED panel of the router.

The Enabled configures whether the alert system should monitor and record matched active alert. If Enabled is not checked, matching active alert will be ignored.

The Renotify Interval configures how often should the matched active alert be notified according to alert filter configuration setting. If it is disabled, no notification will be forwarded.

The Type configures type of the alert definition entry. There are three types available: Simple, Shell and RMON. Currently only the first two types are supported. If users choose Shell type, they should complete parameters under Parameters for Shell table.

The Parameters for Shell table allows user to configure additional parameters if the alert definition entry type is Shell.

The Sample Interval configures how often should the system run configured shell command to get a sample.

The Command configures the shell command to run.

The Comparator configures how to compare with the shell command result.

238 RuggedCom