OPERATION
MEMORY BANK EDIT - STEP 1
Press Menu 
to display the main menu. To display the Memory Bank Setup menu, press 3 
, or move the highlight to the Memory Bank Setup option and press Enter 
. The Memory Bank Setup menu will appear.
MEMORY BANK EDIT - STEP 2
To edit parameters shown in the Memory Bank Setup menu, select the relevant channel and press Enter 
. The Memory Banks menu will appear similar to the sample shown below.
Memory Banks
Memory Label
Bank 3
Switcher 0
Slot 1
List 
Auto Sync 
Protect 
Last Bank
Next Bank
Sync Type | Seperate H,V |
H Freq | |
V Freq | |
Interlaced | Yes |
Memory Banks Menu (SAMPLE)
MEMORY BANK - STEP 3
If desired, edit the following channel setups in the Memory Bank menu:
MEMORY LABEL: An
BANK: A bank number from 01 to 99 can be changed here. NOTE: If you enter a bank number that already exists, a dialog message appears indicating that this number is already in
SWITCHER: “0” represents the projector itself. This will likely always be the case for the
SLOT: 1 (
Input1
), 2 (
Input2
), 3 (
Input3
), or 4 (
Input4
) for projector inputs.
LIST: If checked (default, except for automatically defined banks with unchanged parameters), this defined bank will then appear in the list available when Chan 
key is pressed. If unchecked, the bank must be accessed via Chan 
on the keypad or via the Auto Source function. NOTE:
AUTO SYNC: If checked, (default), the projector can automatically locate this bank when an incoming input signal matches. If not checked, the projector can locate the selected bank only when it is directly selected via on the
PROTECT: If checked, all of the image settings for this bank will be disabled. If unchecked (default), all available settings can be adjusted as desired.
