Runco VX-6C Remote Keypad Protocol IR or Wired Keypad, Step, Opening the Keypad, Set the Jumpers

INSTALLATION AND SETUP

Remote Keypad Protocol - IR OR WIRED KEYPAD -

The standard IR remote keypad or the optional wired remote can be set to one of two different protocols - “A” or “B”. To hard-wire a protocol to “A” or “B” in either remote, follow Steps 1 through 5:

Step 1

Unplug the keypad from the projector (applies to wired remote only).

Step 2

Unlatch and open the empty battery compartment on the back of the keypad as shown below. NOTE: A wired keypad opens as shown, but a cable passes through the battery compartment cover.

Opening the Keypad

Step 3

Find the 4 jumpers located along the latching side of the battery compartment. These jumpers set the keypad protocol and other settings so that the keypad functions in a certain manner.

Step 4: Set the Jumpers

Set the jumpers as shown on the following page. Take care to refer to the correct part of the draw- ing - IR or wired (optional). Use tweezers or needle-nose pliers to remove and replace each jumper as necessary.

2-15