OPERATION
Table 1. System Error Codes
Code Description
GENERAL
12Software bug
13CRC error in flash ROM
14Programming complete
15Attempting to download code without being in boot mode
16Invalid interrupt
LAMP / BALLAST
21Unable to turn the lamp on
22Lamp is overheated
23Lamp ballast (power supply) is overheated
24One or more of the lamp interlocks are open
25Lamp may be on before being turned on
26Invalid lamp ballast ID
27Unexpected lamp
IMAGE PROCESSOR MODULE
31Boot code CRC failed
32Unable to program the Sync Xilinx part
33Unable to program a device on Altera programming bus
34Unable to program a device on JTAG programming bus
35Unrecognized ROM type
36Write to flash ROM failed
37General IPM failure
38Code being downloaded will not fit in ROMs
PANEL DRIVER MODULE / LIGHT ENGINE ELECTRONICS
41Unrecognized Panel Driver Module (PDM)
42Unable to program a device on Panel Driver programming bus
43Panel Driver/light engine communication problem
44Red Formatter/flex cable problem
45Green Formatter/flex cable problem
46Blue Formatter/flex cable problem
POWER & COOLING
51Fan #1 failed (part of Cooling Module)
52Fan #2 failed (part of Cooling Module)
53Fan #3 failed (side fan,
54Fan #4 failed (side fan,
55Low voltage power supply failed to turn on
MOTOR CONTROL MODULE (not in the
61Problem communicating with MCM 
INTERCONNECT OR CHASSIS I.D.
71Unable to access EEPROM on the ICM
72EEPROM memory has
VIDEO DECODER MODULE (INPUT 3 OR 4)
81Unable to program the video decoder (VDM)
OPTIONAL INTERFACE MODULE
91Unable to program the option card
If you encounter a system error, try resetting the projector by powering it off and on again (cooling if necessary).
