Samsung CLX-8380ND manual Installing accessories, Precautions to take when installing accessories

14 Installing accessories

Your machine is a full-featured model that has been optimized to meet most of your printing needs. Recognizing that each user may have different requirements, however, Samsung makes several accessories available to enhance your machine’s capabilities.

This chapter includes:

•Precautions to take when installing accessories

•Installing a memory module

•Replacing the Stapler

•Enabling Fax feature after installing the fax option kit

Precautions to take when installing accessories

Disconnect the power cord

Never remove the control board cover while the power is being supplied on.

To avoid the possibility of an electrical shock, always disconnect the power cord when installing or removing ANY internal or external accessories.

Discharge static electricity

The control board and internal accessories (network interface or DIMM) are sensitive to static electricity. Before installing or removing any internal accessories, discharge static electricity from your body by touching something metal, such as the metal back plate on any device plugged into a grounded power source. If you walk round before finishing the installation, repeat this procedure to discharge any static electricity again.

Installing a memory module

Your machine has a dual in-line memory module (DIMM) slot. Use this memory module slot to install additional memory.

The order information is provided for optional memory module. (Page 13.1)

1Turn the machine off and unplug all cables from the machine.

2Open the control board cover by grasping it and slide toward you.

1

1 control board cover

3Take out a new memory module from the plastic bag.

4Holding the memory module by the edges, align the memory module on the slot at about a 30-degree tilt. Make sure that the notches of the module and the grooves on the slot fit each other.

5Press the memory module into the slot with care until you hear a 'click'.

Note

The notches and grooves illustrated above may not match those on an actual DIMM and its slot.

6Replace the control board cover.

7Reconnect the power cord and printer cable, and turn the machine on.

14.1 <Installing accessories>