Samsung SCX-5315F/5115, SCX-5115 manual Configuring Netware

Configuring Netware

On IPX/SPX protocol networks (for example, Novell NetWare), the format of network communication frames must be specified on the printer. In most cases, you can keep the default setting on “AUTO.” However, you can manually set the frame type format if required.

•AUTO (default): Automatically senses and limits the frame type to the first one detected.

•IEEE802.3: Limits the frame type to IPX over IEEE 802.3 frames. All others are discarded.

•ETHERNET II: Limits the frame type to IPX over Ethernet Frames. All others are discarded.

•IEEE802.2: Limits the frame type to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are discarded.

•SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3 frames. All others are discarded.

Take the following steps to change the frame type format:

1Press Menu/Exit and then System Setup on the one- touch dial keypad. SCX-5115 users should press Menu and then Enter.

2Press or to display “NETWORK SETUP” on the top line.

3Press or to display “CONFIG NETWORK” on the bottom line.

4Press Mode/Enter (Enter for SCX-5115) to access the menu.

5Press or to display “NETWARE” on the bottom line.

6Press Mode/Enter (Enter for SCX-5115).

7Press or to select the frame type you want to set and press Mode/Enter (Enter for SCX-5115).

If you don’t want to enable the Netware protocol, select “OFF”.

8To return to Standby mode, press Stop/Clear.

A.10 INSTALLING A NETWORK OPTION