Savin 1075 appendix Setting Originals

3. Setting Originals

This chapter explains the procedure for placing the original on the exposure glass and in the automatic document feeder (ADF), and setting original scan area and orientation according to the placement method.

To correctly display the top/bottom orientation of the scanned original on a computer, the correct placement must be chosen by setup on the control panel and scanner driver.

There are two orientations for placing the original. See the table below.

Note

❒Normally, the original size is or , but in the table below, a square original is used to make the original orientation easy to understand. If the actual orig- inal size changes, a combination of original orientation and the orientation specified on the control panel or scanner driver does not change.

Scanned original
	Place the original on the ex-		Place the original in the auto-
Select the placement method.	posure glass.		matic document feeder
			(ADF).
	Place the	Place the	Place the top	Place the
Place the original.	original so	original so	edge of the	original so
	that the top	that the top	original first.	that the top
(There are two original orienta-	edge touches	edge touches		edge is set
tions.)	the top left of	the rear of the		into the ADF.
	the exposure	exposure
	glass.	glass.

	When scanned by the
Speci-	delivery scanner, e-mail
	or document server
fy the	(Specified on the con-
orien-
	trol panel)
tation.
	When scanned by the
	TWAIN scanner
	(Specified by the Scan-
	ner Control dialog box)

Original displayed on a compu- ter *1

*1 When sending a gray scale image file in the TIFF (single or multi-page) or JPEG for-
mat, the image may not appear in the same orientation as it was scanned in.	41