Seiko Group TM-L60 manual ESC % n, ESC & s n m ap s Xam-n+l

ESC % n

[Name]

[Format]

[Range]

[Description]

[Notes]

[Default]

[Reference]

Select/cancels user-defined character set. <1B> H <25> H <n>

0 n 255

Selects or cancels the user-defined character set.

•Only the lowest bit of n is valid.

When	n =	<	*******	1>B,	the	user-defined	character	set
is selected.
When	n =	<	*******	0>B,	the	user-defined	character	set

is canceled (and the internal character set is selected.)

•The user-defined characters and a down-loaded bit image can not be defined at the same time.

n = 0

ESC &

ESC & s n m [a[p] s Xa]m-n+l

[Name]	Define user-defined characters
[Format]	<1B>H<26>H<s><n><m>[<a><p1><p2>---<psXa>]m-n+1
[Range]	s = 3
	32	n	m	126
	0	a	12 (Font A)
	0	a	9 (Font B)
	0	p1 ... psXa 255
[Description]	Defines user-defined characters for ANK character codes.
	• “s” specifies the number of bytes in the vertical direction.
	. “n” specifies the beginning ASCII code for the definition and "m"
	the final code. If only one character is defined, use n = m.
	• The allowable character code range is from ASCII code <20> H
	to <7E> H and the maximum number of characters is 95.
	• “a” specifies the number of dots in the horizontal direction.
	• “p” is the dot data for the characters. The pattern for a dots is in
	the horizontal direction from the left side. The remaining dot
		pattern on the right side is space. The amount of data to be
		defined is s X a.
	• After user-defined characters are defined once, they are avail-
		able until another definition is made, until ESC @ is executed, or
		until the printer is turned off.
[Notes]	• The user-defined characters and a down-loaded bit image
		cannot be defined at the same time. If this command is ex-
		ecuted, the down-loaded bit image will be cleared.

29