| • | “mu indicates adjusting direction. | |
|
| When | m = < * * * * * 0>B, positioning is adjusted in the |
|
| normal | direction. |
|
| When | m = <* * * * * * 0>B, positioning is adjusted in the |
|
| reverse | direction. |
| • | "n” means the adjustment amount. It is n/360 inches. | |
[Notes] | • | The setting beyond the tip of a label is not available. If the | |
|
| adjustment amount that goes beyond the label tip is specified, | |
|
| the starting position will be set to the label tip. | |
|
| Thus, any adjustment amount that will cause the printing width | |
|
| on a label to be narrower than 255/360 inches (see the figure | |
|
| below) cannot be set. Specifying such an amount will cause the | |
|
| starting position to be set at 255/360 inches. | |
| • | The default setting for the starting position is about 1.5 mm be | |
|
| low the label tip. | |
| • This command is effective only when ‘label print” is selected. | ||
| • | Make sure to set the starting position by considering the align- | |
|
| ment of the starting position will be split out approx. ±1 mm be | |
|
| cause the paper is bent. | |
| • | This command is valid only after setting for the starting position | |
|
| by executing commands (FF, GS FF, GS <), pressing the PA- | |
|
| PER FEED switch or turning the power on. | |
| • | When position is adjusted in the reverse direction, the position of | |
|
| the first label may shift approx. ±1 mm. To prevent this, feed the | |
|
| first label through the machine without printing on it. | |
|
|
| ••••••••• |
| |
|
|
|
| ||
[Default] | None |
|
|
| |
I | I | ||||
|
| ||||
[Reference] | FF, GS FF |
| |||
|
|
| |||
b default position
b S t a r t i n g p o s i t i o n
(set by this command
GS C 0 m n
[Name] | Select counter print mode |
[Format] | <1D>H<43>H<30>H<m><n> |
[Range] | 0 ≤ m ≤ 5 |
| 0 ≤ n ≤ 2 |
[Description] | Selects print mode for the serial number counter. |
