Sierra S5832SG installation instructions Block 5 - Reporting Digits Programming cont

Block 5 - Reporting Digits Programming (cont.)

Report Code, Report Queue Overflow

Cmd Loc	163	164
Default	0	0
Range	0 - 15	(All	CL)

Comments

This two-digit report code will indicate that the report buffer has over- flowed. When using single-digit reporting formats, only the second digit is sent.

Report Code, SN Keypad Supervisory Failure

Cmd Loc 165

Default 1

Range 0 - 15

Report Code, SN Kpd Supervisory Fail Restoral

Cmd Loc 166

Default 1

Range 0 - 15

Comments

The SpreadNet keypad supervisory (check-in) failure and restoral report codes are a single-digit code. For two-digit reporting formats, the keypad address is sent as the second digit. To disable reporting, program 0 into the specific location.

Report Code, SpreadNet Keypad/Keyfob Low Battery

Cmd Loc	167
Default	1
Range	0 - 15

Report Code, SpreadNet Keypad/Keyfob Low Battery Restoral

Cmd Loc 168

Default 1

Range 0 - 15

Comments

These report codes apply to the SpreadNet keypad, remote, and keyfob. The low battery and restoral report codes are a single-digit code. For two- digit reporting formats, the respective keypad number or user number associated with the remote/keyfob will be sent as the second digit. To disable reporting, program 0 into the specific location.

Report Code, Accessory Tamper

Cmd Loc 169

Default 1

Range 0 - 15

Report Code, Accessory Tamper Restoral

Cmd Loc	170
Default	1
Range	0 - 15

Comments

The respective report code is sent to indi- cate a tamper or trouble condition (or the respective restoral report) associated with

aspecific accessory. For two-digit report- ing formats, a hardcoded address is added as the second digit. The addresses for each accessory are listed to the right.

Accessory Addresses

1 - ZEM #1

2 - ZEM #2

3 - ZEM #3

4 - Not Used (Reserved)

5 - REMM #1

6 - REMM #2

7 - SN915-BUS Receiver

Report Code, Accessory Trouble

Cmd Loc

Default

Range

171

1

0 - 15

Report Code, Accessory Trouble Restoral

Cmd Loc

Default

Range

172

1

0 - 15

Report Code, Keypad Tamper Comments

Cmd Loc

Default

Range

173	174		These two-digit report codes indicate tamper, trouble, and restoral con-
0	1		ditions associated with hardwired keypads. When using single-digit
0 - 15	(All	CL)	reporting formats, only the second digit is sent.

Report Code, Keypad Tamper Restoral

Cmd Loc

Default

Range

175 176

01

0 - 15 (All CL)

Report Code, Keypad Trouble

Cmd Loc

Default

Range

177	178
0	0
0 - 15	(All CL)

Report Code, Keypad Trouble Restoral

Cmd Loc	179	180
Default	0	0
Range	0 - 15	(All CL)

29