Sierra S5832SG Keypad Tamper Switch Enable By Address Keypad #, Reserved for Future Use Comments

Block 3 - Armed System Programming (cont.)

Keypad Tamper Switch Enable (By Address)

Keypad #	1 - 8	9 - 16
Cmd Loc	044	045
Default	0	0
Range	0 - 255	0 - 255

Comments

Each Cmd Loc will be programmed with the total of the keypad addresses with ac- tive tamper switches.

Keypad Tampers are reported via the keypad bus.

Options:

0	Disabled
1	Keypad	1	9
2	Keypad	2	10
4	Keypad	3	11
8	Keypad	4	12
16	Keypad	5	13
32	Keypad	6	14
64	Keypad	7	15
128	Keypad	8	16

Reserved for Future Use			Comments
Cmd Loc	046	047
			These locations are Reserved for Future Use and are not available in this
Default	0	0
			firmware version.
Range	N/A	N/A

External Bell Reverse Enable		Comments	Options:
Cmd Loc	048	If enabled, supplies voltage to external bell when bell is off.	1	No
Default	1	This option may not be used with External Bell Supervision	2	Yes
Range	1 - 2	(Block 3, CL 043) enabled.

Sounder (Bell) Test Enable (By Area)		Comments
Cmd Loc	049	Sounds a 5-second bell test at the start of each exit
Default	0	delay. The value programmed into this Cmd Loc is the
Range	0 - 255	total of all areas for which the bell test will be active.

Options:

0Disabled

1 Area 1

2 Area 2

4 Area 3

8 Area 4

16Area 5

32Area 6

64Area 7

128 Area 8

Home Arming Enable		Comments	Options:
Cmd Loc	050	This option, when enabled, allows a system to be home	1	No
Default	1	armed or instant home-armed. All zones listed in the	2	Yes
Range	1 - 2	Home Arm Bypass List (Block 2, CL 151 - 154) will be
		automatically bypassed.

Keyswitch/SpreadNet Arming Annunciation		Comments	Options:
Cmd Loc	051	This option determines how keyswitch or	0	No Annunciation
Default	0	SpreadNet arming is annunciated. The value	1	Keypad Buzzer
Range	0 - 15	programmed into this Cmd Loc is the total of	2	Strobe
		all sounders to be activated. When arming,	4	Internal Siren
		the selected sounders will beep three times	8	External Bell
		(1.5 sec on/off) and the strobe will light for 3
		seconds. When disarming, the selected
		sounders will beep once and the strobe will
		be on for 1.5 seconds.

Auto-Arming Enable (Day of Week)		Comments	Options:
Cmd Loc	052	This will automatically arm the areas specified in	0	Disabled
Default	0	Block 3, CL 022 at the time specified in Block 3,	1	Saturday
Range	0 - 127	CL 023 and 024. The value programmed here is	2	Friday
		the total for all days of the week when the system	4	Thursday
		will auto-arm.	8	Wednesday
			16	Tuesday
			32	Monday
			64	Sunday
Ground Fault Supervision Enable		Comments		Options:

Cmd Loc

Default

Range

053

1

1 - 2

This option, when enabled, reports and annunciates all	1	No
ground fault conditions.	2	Yes

When disabled, these conditions are not reported or annunciated.

20