Menu Setup 6 Chapter

Extended Menu

Monitor screen

Recording channel numbers

 

ITEM-819

 

AUDIO INPUT SOURCE

 

 

ARRANGE

Input channel numbers

 

 

in1 in2 in3 in4 tape

 

--------------------

 

ch1: *on

on

 

ch2:

on

 

ch3:

on

 

ch4:

on

 

 

 

 

Cursor (shows the item selected for menu operations)

3Holding down the STOP button, turn the search dial to move the cursor to select a combination of input and recording channels.

4Holding down the SEARCH button, turn the search dial to set the channel selection made in step 3 to on or off.

To select an input channel for recording

For the selected recording channel, set the desired input channel to on.

To record, mixing more than one input signal For the selected recording channel, set two or more of the input channels to on. All of the input channels set to on for each recording channel will be mixed for that channel.

To switch on the sound-on-sound setting

In addition to the selected input channel(s), set “tape” to “on.”

5Repeat steps 3 and 4 for each of the recording channels.

6Press the SET button. This saves the settings.

To enable the setting of extension menu item 819

Press the MIXING button in the upper control panel, turning it on.

When the MIXING button is off, the settings of extension menu item 819 are ignored, and the input channels and recording channels are recorded one-to- one. It is not possible to carry out mixing or channel switching.

Note

When 2-channel mode (2CH) is selected for audio recording (see extended menu item 818), the settings made with this item for input channels 3 and 4 (in3 and in4) as well as recording channels 3 and 4 (ch3 and ch4) are invalid.

For example, when input channels 1 and 3 (in1 and in3) are set to on for recording channel 1 (ch1), in 2CH mode, only the signal from input channel 1 is recorded on recording channel 1.

122 Chapter 6 Setup Menu