Sony DSR-2000AP, DSR-2000A Upper Control Panel, Location and Function of Parts

Location and Function of PartsUpper Control Panel

Overview 1 Chapter

1POWER switch

2Audio level meters

1 Input selection/audio mode display section (see below)

2 Input selection section (see page 15)

															INPUT SELECT
POWER																SDTI/i.LINK
	dB OVER dB		dB OVER dB		dB OVER dB		dB OVER dB		INPUT	V:SDTI		SDTI	i.LINK
	0	2	0	2	0	2	0	2								VIDEO IN
									VIDEO	COMPOSITE		Y-R,B S VIDEO SDI		SG
	-12		-12	1	-12	1	-12	1
		1
	-20		-20	0	-20	0	-20	0	CH11/2	ANALOG	AES/EBU		SDI	SG		CH-1,1/2
		0
				-1		-1		-1	AUDIO
	-30	-1	-30		-30		-30			ANALOG	AES/EBU		SDI	SG
									CH23/4
	-40	-2	-40	-2	-40	-2	-40	-2								CH-2,3/4
									PB FS	48k44.1k32k		REC MODE	2CH4CH
	-60	1	-60	2	-60	3	-60	4

MIXING

3Cassette compartment

3 Remote control setting section (see page 16)

REMOTE

9PIN

i.LINK

1POWER switch

Press the “1” side to power the unit on. When the unit is powered on, the display windows in the upper and lower control panels light.

To power the unit off, press the “¬”side of the switch.

2Audio level meters

These show the audio levels of channels 1 to 4 (recording levels in recording mode or E-E mode1) and playback level in playback mode).

There are two modes for audio level indications: FULL and FINE, selected by the METER FULL/FINE button on the lower control panel.

3Cassette compartment

Accepts DVCAM, DV and DVCPRO(25) videocassettes.

For details of usable cassettes, see page 34.

1 Input selection/audio mode display section

1 INPUT display	INPUT	V:SDTI		SDTI	i.LINK
2 INPUT VIDEO display	VIDEO	COMPOSITE		Y-R,B S VIDEO SDI		SG
3 AUDIO CH1, 1/2 display	CH11/2	ANALOG	AES/EBU		SDI	SG
4 AUDIO CH2, 3/4 display	AUDIO	ANALOG	AES/EBU		SDI	SG
	CH23/4
5 PB FS display	PB FS	48k44.1k32k		REC MODE	2CH4CH		6 REC MODE display

.........................................................................................................................................................................................

1)E-E mode: Abbreviation of “Electric-to-Electric mode”. In this mode, video and audio signals input to the VCR are output after passing through internal electric circuits,

but not through magnetic conversion circuits such as heads and tapes. This can be used to check input signals and for adjusting input signal levels.

14 Chapter 1 Overview