Rewriting ClipLink Log Data

Operation ClipLink 5 Chapter

You can rewrite the reel number, Mark IN/OUT points and OK/NG status included in the ClipLink log data.

Changing the Reel Number

To change the reel number of the data item selected on the ClipLink log data list, proceed as follows.

1,36 2,7 4

1Using the search dial, move the selection mark (asterisk) to the desired data item on the ClipLink log data list.

2Hold down the STOP button and press the SET button.

The following setting screen appears.

CLIPLINK LOG DATA LIST

(003/196)

*REEL NO

(XXXXXXXX)

 

 

 

 

 

 

 

 

REEL NO

(YYYYYYYY)

3Turn the search dial to select the digit to change.

Rotating the search dial clockwise moves the current digit position to the right, and counterclockwise moves it to the left.

4Hold down the SEARCH button and turn the

search dial to change the digit indicated by an arrow (µ).

5Repeat steps 3 and 4 until the settings for all digits are complete.

6When all digits have been set, hold down the ENTRY/SHIFT button and press the MARK/+ button.

The reel number changes.

7Hold down the STOP button and press the SET button.

This returns to the original ClipLink log data list.

Note

If you carry out step 7 skipping step 6, the original ClipLink log data list appears again on the monitor and, in this case, the reel number is not rewritten.

Changing Mark IN/OUT Points

To change Mark IN/OUT points selected on the ClipLink log data list, perform the following procedure.

When Mark IN/OUT points are rewritten to the cassette memory, the frame digits of the address data are processed as follows.

For Mark IN point: Any frame-digits value is counted as 1 second.

For Mark OUT point: Any frame-digits value is ignored.

2,7 8

4

6

1,3,5

98

Chapter 5 ClipLink Operation