Automatic Editing
Editing 4 Chapter
To change the OUT point after starting automatic editing operation
After starting the automatic editing operation, to end the operation before the preset OUT point, hold down the ENTRY/SHIFT button and press the OUT button.
The position where you pressed the button becomes the OUT point, and editing ends.
To abandon automatic editing
Press the STOP button.
The automatic editing operation is abandoned. At the same time, the PREVIEW button and AUTO EDIT button start flashing, and the state before the editing was started is restored.
In this case, the IN and OUT points already set are preserved so that you can carry out a preview or automatic editing operation again by pressing the PREVIEW button or AUTO EDIT button.
Reviewing the editing results
After carrying out an editing operation, you can carry out a review, to check the editing results on the monitor.
To carry out a review, after carrying out the edit, and before you set any new edit points or make other settings, press the REVIEW button.
The REVIEW button lights, and the review is carried out.
At the end of the review the REVIEW button goes off, and the tape returns to the OUT point.
After automatic editing, to adjust the edit points and reexecute the edit
Hold down the DELETE button and press the ENTRY/SHIFT button to recall the edit points. After adjusting the edit points, press the AUTO EDIT button to carry out the edit again.
For details of how to adjust edit points, see the section “Modifying Edit Points” (page 75).
82 Chapter 4 Editing