1Press the COUNTER SEL button and select TC.
Time data type indicator TC lights in the display section of the lower control panel.
2Press the HOLD button.
The first digit of the time counter display (hours:minutes:seconds:frames) in the display section begins to flash.
To set all digits to 0 Press the RESET button.
3Confirm the JOG indicator in the display section is lit. If not lit, press the search dial to select jog mode.
4Select the digit to set by rotating the search dial.
The flashing digit changes to the digit on the right when you rotate the search dial clockwise, and to the digit on the left when you rotate it counterclockwise.
5Set the value for the flashing digit by rotating the search dial while pressing the SEARCH button.
6Repeat steps 4 and 5 until you finish setting all digits.
7Press the SET button.
If the FREE RUN/REC RUN switch is set to FREE RUN, the time code starts to advance immediately.
To set time code to the current time
1Set the FREE RUN/REC RUN switch and DF/NDF switch (for DSR- 2000A only) on the subsidiary control panel to FREE RUN and DF, respectively.
2Carry out steps 1 to 6 of the previous section “Setting an initial time code value” to set the time code to a time slightly ahead of the current time.
3Press the SET button at the instant when the current time matches the displayed time code.
Information Text and Data Time Setting/Displaying 2 Chapter
Chapter 2 Setting/Displaying Time Data and Text Information | 41 |