Adding to/Deleting From ClipLink Log Data
You can add new Mark IN/OUT point data to the ClipLink log data or delete Mark IN/OUT point data from the ClipLink log data.
Adding Mark IN/OUT PointsSet the setup menu item 129 (CLIPLINK) to ON beforehand, then proceed as follows.
For information about how to operate the setup menu, see Chapter 6 “Setup Menu” on page 105.
5
2 | 4 | 1,3 |
5Holding down the ENTRY/SHIFT button, press the MARK/+ button.
The ENTRY/SHIFT button goes out, and the Mark IN point and Mark OUT point data is added to the end of the existing ClipLink log data.
Note
The volume of ClipLink log data that can be stored in a cassette memory depends on the cassette memory capacity as follows.
Cassette memory | Storable volume of data |
capacity |
|
|
|
4K bits | 45 pairs of Mark IN and |
| Mark OUT points |
|
|
16K bits | 198 pairs of Mark IN and |
| Mark OUT points |
When adding to the existing ClipLink log data, carefully watch the ClipLink log data list not to allow the additional data to exceed the available cassette memory capacity.
Deleting Mark IN/OUT PointsAfter displaying the ClipLink log data, proceed as follows.
2
Operation ClipLink 5 Chapter
3 1
1Using the search dial, move the selection mark (asterisk) to the desired data item on the ClipLink log data list.
(Continued)
Chapter 5 ClipLink Operation 101