Cuing Up to Mark IN/OUT and Cue Points
To cue up to the point specified by the data item selected on the ClipLink log data list, proceed as follows.
2 1
1Using the search dial, move the selection mark (asterisk) to the desired data item on the ClipLink log data list.
When the selected data item display contains “M” mark
The Mark IN point address is stored as the IN point and the Mark OUT point address is stored as the OUT point. At the same time, the IN button and the OUT button on the control panel light.
When the selected data item display contains “C” mark
The cue point address is stored as the IN point and the IN button on the control panel lights.
2Operate as follows.
•To cue up to the Mark IN point or cue point Holding down the IN button, press the PREROLL button.
•To cue up to the Mark OUT point Holding down the OUT button, press the PREROLL button.
This exits from the ClipLink log data list and cues up to the selected position.
Once you select data on a ClipLink log data list, you can cue up to the point preceding or following the selected data with ease without reverting to the ClipLink log data list.
F FWD button
REW button
MARK/+ button
To cue up to the Mark IN point or cue point preceding the current point selected on the list
Holding down the MARK/+ button, press the REW button.
During the
To cue up to the Mark IN point or cue point following the current point selected on the list
Holding down the MARK/+ button, press the F FWD button.
During the
Operation ClipLink 5 Chapter
Chapter 5 ClipLink Operation | 97 |