Monitor output during an edit
During execution of an automatic edit, on a monitor connected to the recorder, you can monitor the same video and audio as during a preview (see page 80).
However, during preread editing (see page 86), only the playback from the recorder can be monitored.
Using a single monitor for video and audio on both player and recorder
For efficient editing if only one monitor is available, use the following method.
1Connect the monitor to the recorder.
2In the setup menus, set item 008 to “AUTO”.
3Press the PLAYER button on the recorder.
This forces the recorder to
Note
Continuous recording must exist on the recorder tape to be used in issert editing. It is not possible to carry out editing on a section of the tape with no signal recorded.
Starting automatic editing
When you have set the edit points, press the flashing AUTO EDIT button. The AUTO EDIT button changes from flashing to continuously lit, and the automatic editing operation begins.
At the end of the editing operation, the AUTO EDIT button goes off.
ENTRY/SHIFT button
Editing 4 Chapter
DELETE button
AUTO EDIT button
PREVIEW button |
|
|
| |
OUT button | STOP button | |||
| ||||
| REVIEW button |
|
|
Chapter 4 Editing 81