ConnectionsConnectionsfor Cut Editingfor CutUsingEditingi.LINK InterfaceUsing i.LINK Interface

By interconnecting two DSR-2000A/2000AP units with an i.LINK cable (DV cable) and using the one as a player and the other as a recorder, you can configure a cut editing system.

You can also use the same system to digitally dub signals in DVCAM format through an i.LINK interface (see page 61).

It is also possible to use an i.LINK-compatible camcorder such as the DSR-500WS/500WSP as the player and carry out cut editing.

Note

When you edit using the i.LINK connector, with video and audio signal input set to “i.LINK” and remote control set to “9PIN”, the locations where edit points are actually set may not be the same as the specified locations.

When you set video and audio signal input to “i.LINK”, set remote control to “i.LINK” as well.

and Connections 7 Chapter Settings

1

i.LINK

i.LINK

DSR-2000A/2000AP (recorder)

 

 

 

DSR-2000A/2000AP (player)

16-pin to 6-pin i.LINK cable (DV cable)

DSR-2000A/2000AP (recorder and player) settings

Control

Setting (recorder)

Setting (player)

 

REMOTE button

Unlit

Lit

 

 

 

 

 

i.LINK button

Lit

Lit

 

 

 

 

 

SDTI/i.LINK button

i.LINK

i.LINK

 

(input selection section)

 

 

 

 

 

 

 

 

 

 

 

124

Chapter 7 Connections and Settings