Symptom | Cause | Remedy |
The VISCA control is not available with | The computer is not correctly connected to | Make sure the connection between the |
a computer connected to the camera. | the camera. | computer and camera is made correctly. |
|
|
|
|
| Check that the VISCA control setting (RS- |
|
| 232C or |
|
| (9600 bps or 38,400 bps) are properly made |
|
| with the BOTTOM switch on the bottom of |
|
| the camera (page 19) and the DIP switch on |
|
| the Remote Control Unit (page 23). |
|
|
|
|
| Try to connect the camera to the |
|
| Remote Control Unit to check that the camera |
|
| works properly. |
|
|
|
The picture quality obtained from the | Depending on your computer or video capture | Consult with your computer manufacturer or |
camera connected to a computer differs | board, you may not be able to obtain the | dealer for details. |
from that from the camera connected to a | expected picture quality. |
|
video monitor. |
|
|
The camera cannot be operated at all.
—
Pull out the plug of the power cord from the AC outlet, then reinsert it into the AC outlet after a while.
Appendix
66
Troubleshooting
