List of Messages, Indicators on the BRC-H700 camera

Appendix

List of Messages

The following messages may appear on the screen. Take the necessary measures shown below.

Indicator	Meaning/remedies
STANDBY lamp	The camera stopped moving due to an
flashes.	error in the pan/tilt mechanism. Reset
	the pan/tilt position or turn off the power
	of the camera and turn it on again.

The tally lamp	Turn off the power of the camera, and
flashes.	consult with your Sony dealer.

Message	Meaning/remedies
Please restart system	You are prompted to restart the power of
	the camera after you changed the setting
	of “IMG-FLIP” in the SYSTEM menu.
	Use the POWER switch on the supplied
	Remote Commander or the POWER
	button on the RM-BR300 Remote
	Control Unit to turn the power off, then
	on. The changed setting becomes
	effective.

PRESET xx OK	When you store the camera settings into
(xx = 1 to 16)	the memory (POSITION 1-16), the
	message will appear for 2 seconds.

One Push WB...OK	While the white balance is automatically
(NG)	adjusted, the message will appear. Wait
	for a while. When the adjustment is
	complete, it will disappear.

STOP	Turn off the power of the camera, and
(The message will	consult with your Sony dealer.
flash in FAN
MOTOR on PAGE5
in the STATUS
menu.)

CAUTION	Turn off the power of the camera, and
COOLING FAN 1	consult with your Sony dealer.
(2), (1, 2)
STOPPED!

Message	Meaning/remedies
Communication error	The message will appear when the HD
Please check	Optical Multiplex Unit is turned on, if a
connection	problem occurs in the connection of the
	Optical Fiber Cable between the camera
	and the HD Optical Multiplex Unit.
	Turn off the power of the camera and
	the HD Optical Multiplex Unit, check
	the connection of the Optical Fiber
	Cable and turn the powers on again.
	This message will also appear when the
	power of the camera is not turned on.
	Turn off the HD Optical Multiplex Unit,
	turn on the camera, then turn on the HD
	Optical Multiplex Unit again.

Option card error	The message will appear when an
Please check option	interface board that cannot be used with
card	the HD Optical Multiplex Unit is
	inserted into the card slot. Turn off the
	power of the HD Optical Multiplex Unit
	and remove the board.

CAUTION	Turn off the power of the camera, and
COOLING FAN	consult with your Sony dealer.
STOPPED!

List of Messages