Model 9200 Programmable Dual-loop Controller
Highlighting the relay that you wish to assign and pressing the “Enter” key takes you to a screen that has the following choices:
•Loop 1 fwd
•Loop 1 rev
•Loop 2 fwd
•Loop 2 rev
•Loop 3 fwd
•Loop 3 rev
•Programmer alarm
•Alarm 1
•Alarm 2
•Alarm 3
•Event 0 through Event 15
•Burn off
•IN 1 Relay SP A
•IN 1 Relay SP B
•IN 1 Relay SP C
•IN 2 Relay SP A
•IN 2 Relay SP B
•IN 2 Relay SP C
•IN 3 Relay SP A
•IN 3 Relay SP B
•IN 3 Relay SP C
From these choices, you can select which function you wish assigned to Relays 1 through 8.
Pressing the “Esc” key returns you to the “Menu” screen.
Relay Set Points
Highlighting the above menu option and pressing the “Enter” key, moves the operator to the screen below.
Highlighting one of the choices below, allows the operator to change the value of the highlighted selection using the numeric keypad that “pops” up.
SSi Manual SERIES 9200 | 36 | Programmable |
