SSI America 9200

Model 9200 Programmable Dual-loop Controller

SSi Manual SERIES 9200 54 Programmable Dual-loop

Curve Entry

Pressing the “Enter” key makes the following screen appear.

This screen is used to install custom Curve information. It is normally used in Vacuum or Nitriding Furnace

applications, and only should be used after contacting SSi personnel.

Pressing “Esc” will return you to the Main Menu.

Contents

Main Super Systems Inc. Model 9200 Controller Model 9200 Programmable Dual-loop Controller Page Safety Symbols Grounding of the temperature sensor shield Routing of wires Installation requirements for EMC Page Page Page SSi requirement: Never remove the flash card when the Operator Interface is ON. Model 9200 Programmable Dual-loop Controller Chapter 1 - INSTALLATION Status Page Page Page Passcode and Alarm Screen. Page Page Page Page Page Page Model 9200 Programmable Dual-loop Controller Chapter 2 - CONFIGURATION Page Page Page Page Page Page Page Page Page Page SETPT Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Edit Zero input 3 range 2 Calibrate Edit <-- Back Skip Next --> DONE Span input 3 range 2 Calibrate <-- Back Skip Next --> DONE Page Page Page Page Page Page Page Page Chapter 3 - PROGRAMS Page Chapter 4 - SERIES 9200 Opcodes Page Page Page Page Chapter 5 - APPLICATIONS INFORMATION