Model 9200 Programmable Dual-loop Controller
Output Setup
Pressing the “Enter” key takes you to a page similar to the one input setup with the exception that these are outputs, not inputs.
Pressing the “Enter” key when Output 1 is highlighted displays a screen with many parameters listed that could be assigned to Output 1. Remember that this is NOT control output, but an auxiliary output. For example you can
The blue “UP” and “DOWN” arrow keys highlight either Output 1 or Output 2. Pressing the “Enter” key takes you to a List of of outputs. Selecting an output returns a screen similar to the one below.
Parameter | Value |
Assignment |
|
Offset |
|
Range |
|
Pressing the “Esc” key returns you to the configuration menu.
Passcode and Alarm
Highlighting “Passcode and NC/NO” and pressing the “Enter” key takes you to the following screen:
Parameter | Value |
Level 1 Code | 1 |
Level 2 Code | 2 |
Web Level 1 Code | 111 |
Web Level 2 Code | 222 |
No Alarm | Contact is Open (NO) |
Web Change Enable | 1 |
Alarm Text Setup |
|
Alarm 0 | User Alarm 0 |
……… | ……….. |
Alarm 99 | User Alarm 99 |
The values shown in the above table are the default values. The parameter “No Alarm” means that if there is NO CONTROLLER ALARM, the controller alarm relay is NO. Scroll down until “NO ALARM” is highlighted. Press “Enter”. On the numeric keypad use a “1” and press the “Enter” key to change the state of the relay to “Contact is Closed”, and use a “0” and press the “Enter” key to change the state of the relay to “Contact is Open”. This allows the operator to assign the controller alarm as a NC contact such as a 1400° F alarm.
When highlighting a parameter and pressing the “Enter” key a numeric keypad is displayed allowing you to enter your value. Enter that value using the
Alarm 0 through 99
SSi Manual SERIES 9200 | 39 | Programmable |
