This printer will start automatically once the jam has been cleared. In most cases, the printer will continue printing the rest of your document.

Power Off or Cable Problem

The printer driver software cannot access the printer. This error could be caused by one of the following.

1.The printer is Off

2.The printer's parallel cable is not plugged in properly.

3.A problem exists within the cable connection or the parallel cable is not good.

You need to verify if the printer is turned ON and that the left printer status lamp (Green LED) is lit or flashing. Check that the parallel cable is properly connected to the printer and the computer.

Printing

This message indicates that the printer is currently printing your document.

NV-RAM Error

This message indicates a possible problem with the printer's Nonvolatile RAM settings. Turn the printer off, then on again. If the problem does not clear, reinstall the WinType driver. If after reinstalling the WinType driver, the problem persists, contact your dealer or Customer Support.

Fuser Abnormality

This message indicates a possible problem with the printer's fuser assembly. Turn the printer off, then on again. If the problem persists, contact your dealer or Customer Sup- port.

Scanner Abnormality

This message indicates a possible problem with the printer's scanner assembly. Turn the printer off, then on again. If you see this message persistently, then something is wrong with the printer's engine. Call your dealer or Customer Support.

EP (Toner) cartridge missing

This message indicates that the toner cartridge has not been installed or is not installed properly. Open the printer's front cover, install or reinstall the toner cartridge and close the cover.

63

Page 73
Image 73
Star Micronics 4000 user manual Power Off or Cable Problem, Printing, NV-RAM Error, Fuser Abnormality, Scanner Abnormality