Note – There are many other OpenBoot configuration variables. Although these variables do not affect which hardware device is used to access the system console, some of them affect which diagnostic tests the system runs and which messages the system displays at its console. For details, refer to the Netra 440 Server Diagnostics and Troubleshooting Guide (817-3886-xx).

7.To cause the changes to take effect, type:

ok reset-all

The system stores the parameter changes, and boots automatically when the OpenBoot configuration variable auto-boot?is set to true (its default value).

Note – To store parameter changes, you can also power cycle the system using the front panel Power button.

You can issue system commands and view system messages using your local graphics monitor. Continue with your installation or diagnostic procedure, as needed.

If you want to redirect the system console back to the serial management and network management ports, see “System Console OpenBoot Configuration Variable Settings” on page 31.

30 Netra 440 Server System Administration Guide • August 2004

Page 44
Image 44
Sun Microsystems 440 manual To cause the changes to take effect, type