Symantec Critical System manual About port number mapping

32

Installing Symantec Critical System Protection on Windows

About installing Symantec Critical System Protection on Windows

About installing Symantec Critical System Protection on Windows

If this is a first-time installation, you should install, configure, and test

Symantec Critical System Protection components in a test environment.

You should install the Symantec Critical System Protection in the order listed:

■Management server

■Management console

■Agent

You can install the management console and management server on the same computer or on separate computers. You can install agents on any computer. All computers must run a supported operating system.

The management server and management console are supported on Windows operating system.

Note: The installation directory names for the management console and management server must contain printable ASCII characters only. Multi-byte, double-byte, hi-ASCII and non-printable ASCII characters are not supported.

About port number mapping

When you install the Symantec Critical System Protection components, you must specify port numbers through which the components communicate. In a few instances, these port numbers must match.

Table 3-1shows the Symantec Critical System Protection component port numbers that must match.

Table 3-1	Port number mapping
Management server		Management console	Agent
Agent Port			Agent Port
Console Port		Port
Web server		Admin Port
Administration Port