TAG 20 Series manual Power Management Problems, Printer Problems, The printer does not work

The PC card stops communicating properly.

The application may have been reset when the computer is turned off or in Standby mode. Exit and restart the application.

Power Management Problems

The computer does not enter Standby or Suspend mode automatically.

If you have a connection to another computer, the computer does not enter Standby or Suspend mode if the connection is actively in use.

Make sure that the Standby or Suspend time-out is enabled.

The computer does not enter Standby or Suspend mode immediately.

If the computer is performing an operation, it normally waits for the operation to finish.

The computer does not resume from Standby or Suspend mode.

The computer automatically enters Standby or Suspend mode when the battery pack is empty. Do any one of the following:

−Connect the AC or car adapter to the computer.

−Replace the empty battery pack with a fully charged one.

The computer does not enter Suspend mode.

You might be using a PC card that prevents the computer from entering Suspend mode. To enter the mode, stop the communication program and then remove the card or stop the card.

Printer Problems

The printer does not work.

Make sure that the printer is turned on (if it comes with an independent power source) and is online (ready to use).

Make sure that the printer’s signal cable is properly connected.

Troubleshooting 8-13