Telos ZephyrExpress user manual Isdn Connection How do I place a call?

you can reach the right average level but peaks are too loud, make sure the limiter is turned on.

To test the digital compression engine, verify in the Status Screen that both transmit and receive are set to the same coding method (use L3-Stereoas a generic receiver when transmitting with L3-Dual, L3-Stereo, or L3-Joint). If necessary, change the methods using the Codec submenu. Then scroll down the Codec submenu to Loop Mode, and set the mode to Near. After a few seconds, both LOCK LEDs should light. Turn off the Monitor 2 SEND routing switch, and set the Monitor 2 Receive routing switch to A B. Now, any audio you send should be heard in the headphones, after a slight coding delay.

Don’t forget to set Loop Mode back to Off before connecting to the studio.

ISDN Connection

15:How do I place a call?

d1. Tap the DIAL button. A screen like this will appear:

2.Select Manual, Auto, or Recent. Auto lets you select pre-programmed setups; Recent lets you automatically redial numbers you’ve entered manually.

If you select Auto, a screen like this will appear:

Choose a setup from the top of the screen. When you tap, the Go! box will be selected. Tap again to dial that number. If any menu setups were preprogrammed with that Autodial setup, ZephyrExpress will apply them before placing the call. This may change the coding method, audio setups, or even ISDN setup and system behavior depending on how it was programmed.

If you select Manual or Recent, a screen similar to this will appear:

Select a recently-called number or enter a number from the keypad. If you’re entering manually, don’t forget to add any codes or “1” required in your dialing area. If you make a mistake, turn the knob counter-clockwise to back up.

1-24 QUICK RESULTS