Telos ZephyrExpress user manual Monitor Mixers, Level Controls

h

HOT TIP!

If you need line inputs with separate gain or routing controls, you can convert either or both microphones to line level: set the Audio: Microphone Sensitivity adjustments to line +1 dB.

Level Controls

The three large knobs, with black caps, control the send level for their respective inputs. MIC 1 and MIC 2 are mono controls; LINE 1&2 is a stereo control.

Monitor Mixers

Send Routing Switches

There are two of these: one for each of the two stereo monitor circuits. Press to cycle between A, B , A B, and off. This determines which of the two SEND signals — the ones

hmixed by the large black knobs, and showing on the upper VU meters — will be sent to each monitor. Each of the two send signals is mono; you can adjust how they’re panned in the monitors by using the Audio: Monitor1 XMT and Monitor 2 XMT submenus.HOT TIP!Our monitor panning system is very sophisticated and its submenus might not

be immediately intuitive. ThereÕs a full explanation of how they work in the next section of this manual.

Receive Routing Switches

Again, there are two: one of each of the two stereo monitor circuits. Press to cycle between A, B, A B , and off. These determine which of the two signals received via ISDN — the signals displayed on the lower VU meters — will be sent to each monitor. Each received signal is mono; you can adjust how they’re panned in these monitors by using the Audio: Monitor1 XMT and Monitor 2 XMT submenus.

Level Controls

These determine how much of the send and receive signal will be applied to each of the two stereo monitor circuits. Monitor 1’s knobs have gray caps, matching the gray rings around the MON 1 headphone and XLR output jacks on the rear panel. Monitor 2’s knobs have white caps, matching the white rings around the MON 2 headphone jacks on the front and rear panel.

3-4 ZEPHYREXPRESS HARDWARE