
2.8Installation under Windows XP/Server2003 (Parallel interface with Plug & Play Enabled)
1.
2.
3.
4.
Connect the printer to the PC with a parallel interface cable.
Turn on the printer.
Set the printer parameters in the system mode.
B-SX4, B-SX4-CN, B-SX5, and B-SX5-CN
CENTRO. MODE → ECP
PLUG & PLAY→ ON
PLUG & PLAY → ON
Note: For the parameter setting procedure, refer to Section 6.2 Parameter Setting on the Printer.
Turn on the PC
Note: Log on as the user with administrative privilege.
5. After the system is started, new hardware is detected. When the “Found New Hardware Wizard” is displayed, select the “Install from a list or specific location (Advanced)”, then click the [Next] button.
6. Select the “Search for the best driver in these locations”, check the “Include this location in the search” checkbox, then click the [Browse] button. Specify the folder (C:\TEC_DRV) created in Section 2.1, and click the [Next] button.
- 43 -