- 58 -
Label Size
• Width, Height
Specifies the height and width of a label stock size.
Exposed liner width
• Left, Right
Specifies the distance between the edges of the paper backing and the edges of the label. (Set the same
value for the left and right.)
Note: For the B-SP2D, B-419, and B-431 models, set the both exposed liner widths to 0 mm. Instead, set the label
width to the ‘effective print width + left and right exposed liner widths’. Adjust the print position on the label
format with the application.
Automatic Preset Selection
• Selecting stock loads settings from preset
Specifies whether to designate preset print settings for the selected stock.
However, this feature is unavailable and invisible unless a preset setting file has been registered. When
invisible, the printer behaves in the same way when this feature is unselected.
When this checkbox is unchecked, printing is performed according to the current settings, regardless of the
stock type.
When checked, printing is performed based on the preset settings designated for each stock type.
<Procedure>
(1) Set the print settings, such as sensor fine adjustment and print density adjustment, for the selected
stock, and save them as a preset setting file. () 3.1.2 Preset.)
(2) Check the “Selecting stock loads settings from preset” checkbox, and select the created preset file from
the list.
(3) When a stock for which a preset has been designated is used, the print settings saved in such preset
file are called and reflected in printing.
Note: When this feature is used under the condition more than one stock type is used in turns, designate a preset for
each stock type to be used one by one.
Presets need to be created for each printer driver. Since the stock types are shared among different printer
drivers, care must be taken not to designate different presets for the same stock type registered to each printer
driver.
Be sure to create a preset and stock type in pairs for each printer driver.
In the case of the standard stock types, the preset settings are not succeeded with the import/export functions.
Therefore, it is necessary to register the preset settings again after exporting.