- 51 -
Function Description
Support
<Device Line Substitution>
When enabled, the driver will try to use the printer's
Line Commands to draw lines.
When disabled, lines are drawn by using the
Graphic Command.
{
<Default Copies>
Allows setting the number of copies to be printed as
default. If the number of copies is not changed
in the application, this value will be effective.
{
<Disable Copies Limit>
When enabled, a value exceeding “9999” can be
set for the “Default Copies”.
X
Driver Options tab
<Disable User-Defined Paper Size>
When this checkbox is checked, the user-defined
paper size “USER” cannot be used.
X
Resolution Shows the printer’s available resolution. {
Allows creating the illusion of different shades of
gray by varying the pattern of dots.
{
<Color Adjustment>
Allows the flip horizontal, flip vertical, rotation, color
balance adjustment, etc.
{
Dithering
<Dithering Setup>
Allows detailed setting for the selected dithering
method.
{
Graphics tab
Color <Color Control>
Allows setting the color processing.
{
<Print Method>
Allows selecting whether the ribbon is used (thermal
transfer) or not (Direct thermal).
{
<Sensor>
Allows selecting a sensor type used to detect a print
start position.
{
Media settings
<Label Gap>
Allows setting the length of the gap between labels.
{
<Issue Mode>
Allows selecting whether the labels are issued in the
strip mode.
{
<Post-Print>
Allows selecting whether the labels are issued in the
cut mode. Note that the Pause is not supported.
{
<Occurrence>
Allows selecting the cutter operation and specifying
how often labels should be cut.
{
<Interval>
Specifies the number of labels to be printed before a
cut operation. The cutter will cut labels after the
specified number of labels is printed.
{
Issue Settings
<Print Speed>
Allows setting the print speed.
{
{
<Feed>
Specifies the length of label that will feed after
printing.
{
<Backfeed>
Specifies the length of label stock that is retracted
before printing. This entry window is only available
in cut or strip mode.
{
Stock
Fine Adjustment
<Cut/Strip>
For the cut issue, specifies the length of label to feed
before cutting the label.
For the strip issue, specifies the length of label to
feed before peeling the label.
{